News & Insights

Product News

2026-10-27 10:20:50

Photocatalytic Oxidation Waste Gas Treatment: How UV Technology Works and When to Use It

Answer Summary: A photocatalytic oxidation waste gas treatment unit uses ultraviolet light to activate a semiconductor catalyst, most commonly titanium dioxide, generating highly reactive hydroxyl radicals and superoxide ions that oxidize volatile organic compounds and odorous molecules into carbon

Read more

Product News

2026-10-27 09:58:39

What Is a Zeolite Rotor Concentrator and How Do You Specify One for VOCs Abatement?

If you are treating a large exhaust stream that carries a relatively small mass of volatile organic compounds, the economics of direct thermal oxidation often do not work. You end up heating tens of thousands of cubic meters of air per hour to destroy a few hundred kilograms of solvent. A zeolite ro

Read more

Product News

2026-10-27 09:44:34

How to Treat Boiler Flue Gas Denitrification

Answer in brief: Boiler flue gas denitrification is a temperature-window problem before it is an equipment-selection problem. Selective catalytic reduction (SCR) works inside a narrow band, typically around 320 to 400 degrees Celsius for conventional vanadium-based catalysts, and loses effectiveness

Read more

Product News

2026-10-27 09:28:25

How to Control Dust in a Furniture Factory: A Practical Guide to Explosion Safety, Duct Design, and

Answer in brief: Dust control in a furniture factory is an explosion safety problem before it is an environmental compliance problem. Wood dust has a lower explosive limit in the range of roughly 30 to 70 grams per cubic meter depending on wood type and particle size, and its minimum ignition energy

Read more

Product News

2026-10-27 09:10:39

How to Treat Automotive Paint Shop Waste Gas

Answer in brief: Treating waste gas from an automotive paint shop is not a matter of choosing one VOCs unit and installing it at the end of the duct. The workable sequence is to remove paint mist first, then treat VOCs, and to separate the exhaust streams by source. Spray booth exhaust is high in vo

Read more

Product News

2026-10-27 08:44:26

How to Treat Waste Gas in Electronics Factories: A Practical Guide to Dust, Acid Gases, and VOCs

Answer in brief: Waste gas treatment in an electronics factory is not a single-equipment decision. The workable approach is to separate the exhaust streams by pollutant form before selecting hardware. Particulate-laden air is handled with baghouse dust collectors or cartridge filters at conservative

Read more